Cisco Systems 3000 manual Removing and Replacing a Table Top Section, 11-24

Chapter 11 Field-Replaceable Unit Guide

Replacing a Table Top Section

Removing and Replacing a Table Top Section

Step 1 Open the table door.

Step 2 Perform the following actions for specific table top sections:

•If you are replacing the table door or the left-center table top section, remove the table door. See Figure 11 for an exploded diagram of the parts for the door.

•If you are replacing the center table top section, remove the projector. See Figure 7-6for an exploded diagram of the projector assembly.

Step 3 Detach the microphone from the table top section to be replaced. See Figure 7-2for an exploded diagram of the microphone and its attachment hardware.

Step 4 Disconnect the microphone from the audio/video expansion unit, route the cable through the table top section, and remove the microphone.

Step 5 Remove the privacy panel from the table top section to be replaced.

Tip See Chapter 6, “Building the Table Assembly” for exploded drawings of the privacy panels.

Step 6 Remove the screws from the table legs that support the table top section.

Step 7 Move one of the table legs to allow access to the draw bolts.

Note Make sure that the leg still supports both table top sections.

Step 8 Remove the draw bolts between the table top sections on the side that you moved. See Chapter 6, “Building the Table Assembly” for the location of the draw bolts.

Step 9 If required, reposition the table leg so that it fully supports both table sections.

Step 10 Move the table leg on the other side of the table top to allow access to the draw bolts, making sure that the leg still supports both table top sections.

Step 11 Remove the draw bolts between the table top sections on the side that you moved.

Step 12 Separate the table top sections to create a space between the section to be replaced of approximately one inch (2.5 centimeters); this step allows you to remove the splines between the table top sections.

Tip Move the sections to the left and use the space created by the open table door.

Caution Be sure that the legs support all table top sections and do not allow any of the sections to fall.

Step 13 Remove the splines from the slot in the edges of the table top section.

Step 14 Remove the table top section from the table legs.

Step 15 Place the new table top section on the table legs.

Step 16 Place the splines in the slots on the edge of the new table top section.

Step 17 Press the table top sections together.

	Cisco TelePresence System 3000
11-24	OL-14521-01