Cisco Systems 3000 manual Remove the L brackets from the codec, 11-11

Chapter 11 Field-Replaceable Unit Guide

Replacing a Codec Unit—Part Number CTS-CODEC-PRI-G2 (Primary Codec) or CTS-CODEC-SEC (Secondary Codec)

See Chapter 7, “Assembling the Remaining Cisco TelePresence Elements” for additional information. Step 5 Remove the codec from the Display structure.

Step 6 Remove the L brackets from the codec.

See Chapter 7, “Assembling the Remaining Cisco TelePresence Elements” for additional information. Step 7 Remove the cable management bar from the codec. Retain the bar and the screws.

See Chapter 7, “Assembling the Remaining Cisco TelePresence Elements” for additional information. Step 8 Attach the L-brackets and Cable management bar to the replacement codec.

See Chapter 7, “Assembling the Remaining Cisco TelePresence Elements” for additional information. Step 9 Attach the codec to the display structure front feet using the screws that you removed in Step 4.

Step 10 Turn the codec power switch to the On position.

Caution Make sure each PDU power switch is still in the Off position.

Step 11 Reattach the cables according to your temporary masking tape identification.

See Chapter 8, “Routing Power and Signal Cables”, for additional information.

Step 12 Attach the cables to the cable management bar using tie wraps.

Step 13 If the replacement unit was the Primary codec, follow these steps.

a.Open a browser on a computer connected to the network.

b.Access the Cisco Unified Communications Manager interface.

c.Change the MAC address for the Primary codec to its new address.

Step 14 Power on the system by turning the power switches to the On position on the two left PDUs, single right PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.

Step 15 In the browser on the computer, type in the IP address of the primary codec unit.

Step 16 Enter the required information at the login screen. The Cisco TelePresence Administrator window appears.

Step 17 Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the window) is Enabled/Up.

Step 18 Select Hardware Setup to verify the cameras, displays, speakers, and microphones are working properly.

Step 19 Perform the Auto Adjust camera setup procedure. This sets the white balance to the correct levels. See the “Setting Up the Cameras” section on page 9-7for detailed instructions.

Note If you are replacing the primary codec, power it on and complete all steps before powering on the secondary codecs. This prevents the secondary codecs from being affected by any software and peripheral upgrades to the primary codec.

	Cisco TelePresence System 3000
OL-14521-01		11-11