Cisco Systems 3000 manual Projector Setup With an Auxiliary Control Unit

Chapter 9 First-Time Setup

Setting Up CTS Components

If the input image is displaying correctly, you should see an image projected on the projection surface.

Step 17 If the image is out of focus or is too small, use the projector focus ring to focus the image and use the zoom lever to create the largest possible image.

Step 18 Click Stop in Cisco TelePresence System Administration to remove the test pattern and complete the projector test.

Projector Setup With an Auxiliary Control Unit

If your system has an Auxiliary Control Unit, set up the projector for first-time use by completing the steps in this section.

Step 1 Make sure that a serial cable is connected from your projector to the Serial 1 output of the auxiliary control unit. See the “Options for the Cisco TelePresence System 3000” chapter of the

Cisco TelePresence Hardware Options and Upgrade Guide for information about cabling your system with an Auxiliary Control Unit.

Step 2 Start a test pattern display for the projector by completing the following steps:

a.Open a browser that is connected to the network.

b.Enter the IP address of the primary codec to log in to Cisco TelePresence System Administration.

c.Select Troubleshooting > Hardware Setup, then click the Presentation Devices radio button.

d.Select the Test Pattern radio button.

e.Click Start to begin the test.

Step 3 Turn on the projector by turning the projector power rocker switch to the ON position.

The projector takes approximately 15-30 seconds to warm up, and should be fully initialized within one minute. If the projector is not receiving video, the screen will be blue. If the projector does not receive video for five minutes and 30 seconds, the projector turns off.

If the test pattern is displaying correctly, you should see a grid projected on the projection surface. In the center of the grid, you should see a series of horizontal grey bars. You should also see a one-pixel wide green border around the outside of the grid.

Step 4 From Cisco TelePresence System Administration, click Set Projector Defaults to automatically configure the projector for use with the CTS-3000.

Step 5 Set the group, number and data settings by completing the following steps:

Note Changing these settings allows a projector to be monitored by SNMP when the projector is in an inactive state. If a projector lamp fails, SNMP does not properly report the failure from an inactive projector until you complete these steps.

Tip Use the projector remote control or press the buttons on the projector to complete these steps.

a.Press the Menu key for 20 seconds.

The letter S displays in the upper left corner of the screen.

b.Press the Screen key for 3 seconds. The service menu displays.

	Cisco TelePresence System 3000
OL-14521-01		9-19