Cisco Systems 3000 manual Loading CTS Administration Software, Hood Assembly Figure

C H A P T E R 9

First-Time Setup

Revised: February 6, 2009, OL-14521-01

After you have assembled the Cisco TelePresence System (CTS), you set up the individual system components (such as displays and cameras) using Hardware Setup, located under Troubleshooting in the CTS Administration software. This chapter explains how to initially set up CTS components and contains the following sections:

•Loading CTS Administration Software, page 9-1

•Setting Up CTS Components, page 9-4

Note You cannot perform diagnostics during an active Cisco TelePresence system call.

Parts List

Key	Part Description	Part Number	Qty	Ctn	Notes
Camera	Hood Assembly (Figure 9-7)
1	Camera assembly	68-2900-xx	1	2
2	Camera hood cover: top		1	2
3	Camera hood cover: bottom		1	2
7	M4 x 20mm Pan Head screws	48-0654-01	4	2

Loading CTS Administration Software

CTS Administration Software is factory-installed on each codec and loads during initial bootup.

To load CTS Administration Software:

Step 1 Power on the three PDUs in that are located on the accessory cabinets and the single PDU that is underneath the first row table (near the projector). If you use the Auxiliary Control Unit, power on that unit as well.

Cisco TelePresence System 3000

OL-14521-01 9-1