Cisco Systems 3000 manual Show All Camera Targets, Flipping the Video Image, Focus the Camera

Chapter 9 First-Time Setup

Setting Up CTS Components

Figure 9-6 Correct Camera Target Alignment—Left Display

Red

Vertical line

Red plus sign within black cross

Red lines

205766

Table edge

•Click Hide Camera Target to remove the alignment images.

•Click Done when you complete the adjustment.

Show All Camera Targets

•Click Show All Camera Targets to align each camera independent of the other cameras.

Flipping the Video Image

•Click Flip Video on Each Display to display a mirror image—meaning to simulate the image that attendees will see—for the selected screen(s). Use this feature to make sure all three cameras are vertically aligned.

Focus the Camera

•Place the small target on the table.

•Click Setup, then click Show Focus Target.

•Adjust the small target so that the green box encloses some of the patterns on the small target.

•Adjust the focus ring on the camera lens so the lines on the target are in focus. The ring is labeled “N – 8”. The thumbscrew (or 0.9 mm Allen wrench) is used to unlock the focus ring.

•Click Hide Focus Targets, then click Done when you complete the adjustment.

Attaching the Camera Hood Assembly

•After you complete the camera adjustment, attach the camera hood assembly. See Figure 9-7.

Note Attach the top hood before attaching the bottom hood.

Caution Do not overtighten the screws, or use a power screwdriver to tighten the screws. In addition, make sure that you use screws of the correct length (20 mm). Overtightening the screws, or using a screw that is too long, can cause the plastic hoods to break.

	Cisco TelePresence System 3000
9-10	OL-14521-01