Cisco Systems 3000 manual System IP Address

Chapter 9 First-Time Setup

Loading CTS Administration Software

Figure 9-2 System IP Address

Note Note If the IP address that displays is 192.168.100.2, the CTS-3000 could not contact the DHCP server or your system does not use DHCP. If your network does not use DHCP, navigate to Configuration > IP Settings, change the DHCP Enabled setting to No, and specify a static IP address, subnet mask, gateway and DNS server.

Step 2 After successful bootup, the CTS Administration Software loads. When CTS Administration Software loading is complete, the Cisco IP telephone displays a welcome message, which displays the IP address from which you will be able to access the CTS Administration software. The welcome screen only appears the first time the system is booted up after initial installation or after a factory reset.

Note The telephone will not be registered at this time. It will show a directory number of 7000 but the telephone will not function as a telephone at this time.

Step 3 Make a note of the IP address that appears on the display. You use this IP address to log in to the Cisco TelePresence System administration console.

Step 4 If you have not already done so, configure the your Cisco Unified IP Phone in the

Cisco Unified Communications Manager IP Phone Device page. For detailed instructions to configure Cisco Unified Communications Manager for use with your CTS-3000, refer to the

Cisco Unified Communications Manager Installation Guide for the Cisco TelePresence System for your software release.

Cisco TelePresence System 3000

OL-14521-01 9-3