Cisco Systems 3000 manual Replacing the Projector-Part Number CTS-PRJTR-GEN1, 11-19

Chapter 11 Field-Replaceable Unit Guide

Replacing the Projector—Part Number CTS-PRJTR-GEN1

Replacing the Projector—Part Number CTS-PRJTR-GEN1

Step 1 Power off the projector by turning off the power switch located on the back of the unit. Step 2 Unplug the VGA cable from the back of the unit.

Step 3 Unplug the power cable from the back of the unit.

Step 4 Remove two of the six screws that hold the projector assembly to the underside of the center tabletop. These screws are the rear-most of the six screws and the furthest away from the projector lens.

Step 5 Loosen the remaining four mounting screws.

Note You might have to remove the screws and remove the assembly during this step, rather than loosen the screws. Be sure to secure the projector when you remove the screws.

Step 6 Remove the projector assembly by sliding the unit to the side until the projector mounting bracket disengages from the loosened mounting screws.

Note On some CTS-3000 models, you remove the projector assembly by sliding it to the front, rather than the side.

Step 7 Remove the screws that attach the mounting plate to the projector and remove the plate. Step 8 Attach the mounting plate to the replacement projector.

Step 9 Reattach the assembly to the underside of the tabletop.

Step 10 Reattach the VGA cable to the projector.

Step 11 Reattach the power cable to the projector.

Step 12 If your system uses an auxiliary control unit, reattach the serial cable to the auxiliary control unit. Step 13 Perform the first-time setup procedure for the projector.

See the “Setting Up the Projector” section on page 9-15for more information.

Note Follow the procedure that is specific to your system configuration. The procedure to follow depends on whether your system uses an auxiliary control unit.

	Cisco TelePresence System 3000
OL-14521-01		11-19