Chapter 11 Field-Replaceable Unit Guide

Replacing a Plasma Display—Part Number CTS-DISP-65-GEN2

If your projector screen does not have side trims and is flush with the display cabinet, grasp the outer edges of the screen and pull it up and away from the Projector clips that hold the screen to the Display shelves.

Step 15 Disconnect the Speaker cables from the Speaker terminals.

Step 16 Loosen the half-turn bolts on either side of the left Speaker board. Slip the Speaker board over the half-turn bolts and remove it from the work area.

Step 17 If you are replacing the center or right Plasma display, remove the center speaker board by repeating Step 15 and Step 16.

Step 18 If you are replacing the center Plasma display, proceed to the next section, “Removing the Camera Cluster”.

Step 19 If you are replacing the right Plasma display, remove the right speaker board by repeating Step 15 and Step 16.

Step 20 If you are replacing the right Plasma display, skip to the “Removing the Left Tabletop Door Section” section on page 11-5.

Removing the Camera Cluster

If you are replacing the center Plasma display, you must remove the camera cluster. Refer to the previous section, Removing the Camera Cluster for this procedure.

Removing the Left Tabletop Door Section

The left tabletop door section must be removed to allow room to move the Plasma displays in and out of the work area.

Note Make sure to retain all screws, connectors, and other parts during the disassembly.

Step 1 Remove the safety straps from the underside of the left tabletop section.

Step 2 Unscrew one side of the hinges connecting the left tabletop door section to the left Table segment. Step 3 Remove the left tabletop door section and set it aside.

Removing a Display Shelf

Note Make sure to retain all screws, connectors, and other parts during the disassembly.

Step 1 Unscrew the left Accessory cabinet from the left Accessory cabinet attachment bracket. Remove the Accessory cabinet from the work area.

Step 2 From the underside of the left Display shelf, unscrew one side of each metal plate connector.

 

 

Cisco TelePresence System 3000

 

 

 

 

 

 

OL-14521-01

 

 

11-5

 

 

 

 

 

Page 183
Image 183
Cisco Systems 3000 manual Removing the Left Tabletop Door Section, Removing a Display Shelf, 11-5