Cisco Systems 3000 manual Replacing a Table Top Section, 11-23

Chapter 11 Field-Replaceable Unit Guide

Replacing a Table Top Section

Caution Make sure that all remaining shelves stay on the display structure and do not fall between the structure supports.

Tip Slide the shelves to the left; there is space on the left that is created by the open table door.

Step 10 Remove the splines from the slot at both edges of the shelf to be replaced.

Step 11 Place the new shelf on the display assembly.

Step 12 Place the splines in the slots at the edges of the new shelf.

Step 13 Press the shelves together.

Step 14 Attach the new shelf to its adjoining shelf or shelves using the splines.

Step 15 From the underside of the display structure, insert the draw bolts and tighten them; then, attach the connecting plate between the new shelf and its adjoining shelf or shelves.

Step 16 Attach the screws that connect the display shelves to the display assembly.

Step 17 Reattach the speaker boards and speaker cables. See Chapter 7, “Assembling the Remaining Cisco TelePresence Elements” for detailed instructions.

Step 18 Reattach the projector screen.

Tip The projector screen comes with printed instructions that should assist you with replacing it. If you cannot find the instructions, reverse the order of removal to install it.

Step 19 Power on the system by turning the power switches to the On position on the two left PDUs, single right PDU, and (if present) auxiliary control unit or PDU on the rear center of the display assembly.

Replacing a Table Top Section

Complete these steps to replace a table top section.

Required Information, Tools, and Equipment

To remove and replace a table top section, you need the following tools:

•Medium and large Phillips screwdriver

•10 mm wrench

Tip A 10 mm open end ratcheting wrench is useful to loosen and tighten the draw bolts.

Note Make sure to retain all screws, connectors, and other parts during the disassembly.

	Cisco TelePresence System 3000
OL-14521-01		11-23