9-11
Cisco ASA 5500 Series Configuration Guide using ASDM
Chapter9 Configuring Trend Micro Content Security
CSC SSM Setup
•To remove additional traffic details for CSC scanning, click Delete.

Specifying Traffic for CSC Scanning

To define, modify, or remove additional settings for selecting traffic for CSC scanning, perform the
following steps:
Step1 In the Traffic Selection for CSC Scan screen, click Specify traffic for CSC Scan.
The Specify traffic for CSC Scan dialog box appears.
Step2 Choose the type of interface to the CSC SSM from the drop-down list. Available settings are global (all
interfaces), inside, management, and outside.
Step3 Choose the source of network traffic for the CSC SSM to scan from the drop-down list.
Step4 Choose the destination of network traffic for the CSC SSM to scan from the drop-down list.
Step5 Choose the type of service for the CSC SSM to scan from the drop-down list.
Step6 Enter a description for the network traffic that you define for the CSC SSM to scan.
Step7 Specify whether or not to allow the CSC SSM to scan network traffic if the CSC card fails. Choose one
of the following options:
•To allow traffic through without being scanned, click Permit.
•To prevent traffic from going through without being scanned, click Close.
Step8 Click OK to save your settings.
The added traffic details appear on the CSC Setup Wizard Traffic selection for CSC Scan screen.
Step9 Click Cancel to discard these settings and return to the CSC Setup Wizard Traffic selection for CSC
Scan screen. If you click Cancel, ASDM displays a dialog box to confirm your decision.
What to Do Next
See the “CSC Setup Wizard Summary” section on page9-11.
CSC Setup Wizard Summary
To review the settings that you have made with the CSC Setup Wizard, perform the following steps:
Step1 Choose Configuration > Trend Micro Content Security > CSC Setup > Summary.
The CSC Setup Wizard Summary screen shows the following display-only settings:
•The settings that you made in the Activation Codes Configuration screen, including the Base
License activation code and the Plus License activation code, if you entered one. If not, this field is
blank.
•The settings that you made in the IP Configuration screen, including the following information:
–
IP address and netmask for the management interface of the CSC SSM.
–
IP address of the gateway device for the network that includes the CSC SSM management
interface.