[N] Next port—This option is used to forward to the next configurable port.

[G] Goto port—This option is used to configure any identified port.

[P] Previous port—This option is used to configure the previous configurable port.

[X] Exit to Main Menu—This option returns you to the Main Menu.

Let’s take a look at the options available on the 2820 using an FDDI module on port A1:

Catalyst 2820 − Port A1 Configuration (Left Slot)

Module

Name: FDDI (Fiber SAS

Model). Version 00

Description: Single Attached Station

Ring Status: Not operational

 

802.1d

STP State: Blocking

Forwarding: 0

——————————————————Settings——————————————————————

[D]Description/name of port

——————————————————Module Settings———————————————

[M] Module

status

Suspended−ring−down

[I] Port priority (spanning tree)

128 (80 hex)

[C] Path

cost

(spanning tree)

100

[H] Port

fast

mode (spanning tree)

Disabled

[L] Novell

SNAP frame translation

Automatic

[U]Unmatched SNAP frame destination All

——————————————————Actions————————————————————————

R] Reset

module

[F] Reset to factory defaults

——————————————————Related Menus——————————————————

[1]

Basic FDDI settings

[2]

Secondary

FDDI settings

[A] Port

addressing

[V] View port

settings

[N] Next

port

[G] Goto port

 

[P] Previous port

[X] Exit to Main Menu

Enter Selection:

The following list shows the menu options and an explanation of each:

[M] Module status—This feature has three options. To see the status of the module, use the S option; the other two choices let you either enable or disable the module.

[I] Port priority (spanning tree)—This option sets the port priority for the STP root port. The lower the number, the higher the priority. The valid range is from 0 to 255; the default is 128.

[C] Path cost (spanning tree)—This option sets the path cost used to choose the STP root port.

[H] Port fast mode—PortFast is an option that allows a port to immediately go into forwarding mode. This option offers two settings: E (enable) and D (disable). (The option is explained in detail in Chapter 10.)

[L] Novell SNAP frame translation—This option determines whether manual or automatic frame−translation is used by IPX.

[U] Unmatched SNAP frame destination—This option identifies the translation of frames for which the frame type cannot be determined. To use this option, option L should be set to automatic.

[R] Reset module—This option resets the expansion modules.

[F] Reset to factory defaults—This option resets the expansion modules’ configuration to the factory defaults.

[1] Basic FDDI settings—This option allows you to see the first expansion module’s status and current configuration.

[2] Secondary FDDI settings—This option displays the second screen of the expansion module’s status and current configuration.

[A] Port addressing—This option is used to access the Port Addressing menu.

[V] View port settings—This option is used to display an individual port’s statistics.

[N] Next port—This option is used to forward to the next configurable port.

[G] Goto port—This option is used to configure any identified port.

[P] Previous port—This option is used to configure the previous configurable port.

[X] Exit to Main Menu—This option returns you to the Main Menu.

291

Page 307
Image 307
Cisco Systems RJ-45-to-AUX manual 291