Cisco Systems RJ-45-to-AUX manual Lab Objectives, 354

Mod MAC−Address(es) Hw Fw Sw

——————————————————————————————————————— ———— ——————— ——————————————————

1	00−50−bd−a0−b0−00	to	00−50−bd−a0−b3−ff	2.0	3.1.2	5.5(2)
2	00−50−0f−b7−ff−50	to	00−50−0f−b7−ff−67	3.1	4.3(1)	5.5(2)

Mod Sub−Type Sub−Model Sub−Serial Sub−Hw

—————————— ————————— —————————— ——————

1 NFFC WS−F5521 0011455134 1.1

Catalyst5000> (enable)

∙One Cisco 1912EN using version 9 of the Catalyst IOS, as shown here (1924EN, 2822, or 2828 are great Access layer substitutes with Enterprise Network Edition of the CLI−based IOS):

1912EN#show version

Cisco Catalyst 1900/2820 Enterprise Edition Software Version V9.00.00

Copyright (c) Cisco Systems, Inc. 1993−1999

1912EN uptime is 9day(s) 10hour(s) 26minute(s) 36second(s)

Cisco Catalyst 1900 (486sxl) processor with 2048K/1024K bytes of memory Hardware board revision is 5

Upgrade Status: No upgrade currently in progress.

Config File Status: No configuration upload/download is in progress 15 Fixed Ethernet/IEEE 802.3 interface(s)

Base Ethernet Address: 00−30−80−54−6C−00

∙One Cisco 2600 router. (Any Cisco router from the 2600 series through the 7000 series will work fine as a substitute as long as it has at least two 10/100 Ethernet ports. A 10Mbps attachment unit interface [AUI] port will not work, because Inter−Switch Link [ISL] needs to use a 100BaseTX port for optimum trunking support.)

Note For this lab, the Cisco 2620 series router has been previously configured with its basic configuration.

∙Two Ethernet crossover cables to run between devices.

∙One console cable and connector.

Lab Objectives

During this lab, you will complete the following tasks:

∙Configure the basic switch configuration on the Cisco 1912EN. Configure the basic passwords, the hostname, and IP information. Set up three VLANs: VLAN 2, named CAD; VLAN 3, named Graphics; and VLAN 4, named DocProduction.

∙Configure the basic switch configuration on the Cisco Catalyst 5000. Configure the basic passwords, the hostname, and IP information.

∙Enable trunking on port f0/27 on the 1912EN to trunk to port 2/2 on the Cisco Catalyst 5000 using Dynamic ISL (DISL) on the 1912EN side and ISL on the Catalyst 5000 side.

∙Create a trunk port on the Catalyst 5000 port 2/24 to the Fast Ethernet 0/2 interface on the 2600 router using ISL.

∙Enable a VLAN Trunking Protocol (VTP) domain named Coriolis. Make the 1912EN a VTP server and the Catalyst 5000 a client in order to propagate the 1912EN’s VLAN configuration.

The diagram shown in Figure D.1 illustrates the configuration.

354