Cisco Systems RJ-45-to-AUX manual Following commands are available in Privileged Exec mode

Router(config)#interface e0/0.? <0−4294967295> Ethernet interface number Router(config)#interface e0/0.1 Router(config−subif)#

Let’s take a look at the commands available in the User EXEC mode of a Cisco Catalyst 1912 EN switch:

SeansSwitch>?
Exec commands:
enable	Turn	on privileged	commands
exit	Exit	from the EXEC
help	Description of the		interactive help system
ping	Send	echo messages
session	Tunnel to module
show	Show	running system information

terminal Set terminal line parameters SeansSwitch>

The following commands are available in Privileged EXEC mode:

SeansSwitch#?
Exec commands:
clear	Reset functions
configure	Enter configuration mode
copy	Copy	configuration or firmware
delete	Reset configuration
disable	Turn	off privileged commands
enable	Turn	on privileged commands
exit	Exit	from the EXEC
help	Description of the interactive help system
menu	Enter menu interface
ping	Send	echo messages
reload	Halt	and perform warm start
session	Tunnel to module
show	Show	running system information
terminal	Set terminal line parameters
vlan−membership VLAN		membership configuration
SeansSwitch#

Finally, the following commands are available in Global Configuration mode:

SeansSwitch(config)#?
Configure commands:
address−violation	Set address violation action
back−pressure	Enable back pressure
bridge−group	Configure port grouping using bridge groups
cdp	Global CDP configuration subcommands
cgmp	Enable CGMP
ecc	Enable enhanced congestion control
enable	Modify enable password parameters
end	Exit from configure mode
exit	Exit from configure mode
help	Description of the interactive help system
hostname	Set the system’s network name
interface	Select an interface to configure
ip	Global IP configuration subcommands
line	Configure a terminal line
login	Configure options for logging in
mac−address−table	Configure the mac address table
monitor−port	Set port monitoring
multicast−store−and−forward	Enables multicast store and forward
network−port	Set the network port
no	Negate a command or set its defaults
port−channel	Configure Fast EtherChannel
rip	Routing information protocol configuration
service	Configuration Command

26