Cisco Systems RJ-45-to-AUX manual Configuring the LES/BUS, Configuring a LEC for an Elan, 179

LANE	Server:	47.00817200000000E04BAAA006.00E04BAAA061.**
LANE	Bus:	47.00817200000000E04BAAA006.00E04BAAA062.**

LANE Config Server: 47.00817200000000E04BAAA006.00E04BAAA063.00

note: ** is the subinterface number byte in hex

Note The asterisks in this example indicate that the addresses are in hexadecimal. The ATM LANE module does not list these addresses with this command.

Configuring the LES/BUS

Follow these steps to configure a LES/BUS for two ELANS—the default ELAN and ELAN2:

1. Enter Global Configuration mode on the LANE module:

ATM#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

2.Enter Interface Configuration mode for the ATM0 interface, subinterface 1, and indicate whether the link is point−to−point or multipoint:

ATM(config)#interface atm0.1 point−to−point

3. Make this subinterface the Ethernet default LES/BUS and identify the ELAN:

ATM(config−subif)#lane server−bus ethernet ELAN2

Note You cannot configure more than one LES/BUS per subinterface.

4.Repeat Steps 2 and 3 for each LES/BUS you want to configure on this LANE module.

5.Enter Interface Configuration mode for the ATM0 subinterface 2:

ATM(config−subif)#interface atm0.2

6. Map the LES bus to the Ethernet ELAN named ELAN2:

ATM(config−subif)#lane server−bus ethernet ELAN2

ATM(config−subif)#end

Verifying the LES/BUS Configuration

To verify the configuration, issue the following command:

ATM#show lane server

LE Server ATM0.1 ELAN name: default Admin: up State: operational

type: ethernet	Max Frame Size: 1516
ATM address: 47.00918100000000E04FACB401.00100DAACC41.01

LECS used: 47.007900000000000000000000.00A03E000001.00 NOT yet connected

LE Server ATM0.2 ELAN name: TEST_ELAN		Admin: up State: operational
type: ethernet	Max Frame Size:	1516

ATM address: 47.00918100000000E04FACB401.00100DAACC41.02

LECS used: 47.007900000000000000000000.00A03E000001.00 NOT yet connected

Configuring a LEC for an ELAN

Follow these steps to configure two LECs for two ELANS—the default ELAN and ELAN2:

1. Enter Global Configuration mode on the LANE module:

ATM#configure terminal

Enter configuration commands, one per line. End with CNTL/Z.

2. Enter Interface Configuration mode for the ATM0 interface, subinterface 1:

179