Cisco Systems RJ-45-to-AUX manual Configuring Long Aging on the Catalyst

Configuring Long Aging on the Catalyst 6000

To configure the long aging time on the Catalyst 6000, use the following command:

mls aging long <seconds>

An example of using the mls aging long command is as follows:

mls aging long 64

Disabling Long Aging on the Catalyst 6000

To disable the long aging time on the Catalyst 6000, use the following command:

no mls aging long

Configuring Normal Aging on the Catalyst 6000

To configure the normal aging time on the Catalyst 6000, use the following command:

mls aging normal <seconds>

An example is as follows:

mls aging normal 32

Disabling Normal Aging on the Catalyst 6000

To disable the normal aging time on the Catalyst 6000, use the following command:

no mls aging normal

Assigning MLS Management to an Interface on the Catalyst 5000

To enable an interface to be a management interface, follow these steps:

1. Enter Interface Configuration mode on the interface using the following command:

CAT5000(config)interface fastethernet 1/1

2. To enable the interface as the management interface, use the following command:

CAT5000(config)mls rp management−interface

Disabling MLS Management on an Interface on the Catalyst 5000

To disable a management interface, perform the following tasks:

1. Enter Interface Configuration mode on the interface using the following command:

CAT5000(config)interface fastethernet 1/1

2. To disable the interface as the management interface, use the following command:

CAT5000(config−if)no mls rp management−interface

239