Cisco Systems RJ-45-to-AUX manual Usage Summaries, 296

The following list explains the options available from the RS−232 Interface Configuration menu:

∙[B] Baud rate—Lets you enter the baud rate. The possible settings are 2400, 9600, 19200, 38400, or 57600 for the console port. The default baud rate is 9600.

∙[D] Data bits—Allows the configuration of data bits for the console port. The possible options are 7 and 8. The default is 8.

∙[S] Stop bits—Allows the configuration of the stop bit value for the console port. The default is 1.

∙[P] Parity setting—Changes the parity settings for the console port. The default is None.

∙[M] Match remote baud rate (auto baud)—Allows you to enable or disable the console port from automatically matching the baud rate of an incoming call. The switch only matches a baud rate that is lower than its configured baud rate.

∙[A] Auto answer—Allows you to enable the switch to automatically answer incoming calls or disable it from doing so.

∙[N] Number for dial−out connection—Lets you enter the phone number the switch is configured to use when dialing out. This number is dialed when the switch is configured to communicate with a remote terminal upon power−up or power recycling.

∙[T] Time delay between dial attempts—Configures the number of seconds between dial−out attempts. Zero (0) disables all retries. The default is 300 seconds.

∙[I] Initialization string for modem—Allows you to change the initialization string to match your modem requirements.

∙[C] Cancel and restore previous group settings—Allows you to undo any new values entered for the baud rate, data bits, stop bits, and parity settings.

∙[G] Activate group settings—Allows you to activate the settings you have entered for baud rate, data bits, stops bits, and parity.

∙[X] Exit to Main Menu—Returns you to the Main Menu.

[U]Usage Summaries

The Usage Summaries menu allows you to receive usage and summary reports. You can receive five types of reports based on the options shown here:

Catalyst 1900 − Usage Summaries

[P]Port Status Report

[A]Port Addressing Report

[E]Exception Statistics Report

[U]Utilization Statistics Report

[B]Bandwidth Usage Report

[X]Exit to Main Menu

Enter Selection:

The following list explains the options from the Usage Summaries menu:

∙[P] Port Status Report—This option displays the Port Status Report, which displays the current connection status of ports. A sample of this report is as follows:

Catalyst 1900 − Port 3 Statistics Report
Receive Statistics		Transmit Statistics
————————————————————————————————————		—————————————————————————————————————
Total good frames	9342	Total frames	90269
Total octets	983976	Total octets	6147813
Broadcast/multicast frames	834	Broadcast/multicast frames	81389
Broadcast/multicast octets	133139	Broadcast/multicast octets	5492328
Good frames forwarded	9342	Deferrals	1
Frames filtered	0	Single collisions	0
Runt frames	0	Multiple collisions	0
No buffer discards	0	Excessive collisions	0
		Queue full discards	0

296