Conair GB Set Material Types, The Keystroke sequence to set, Press, Display will, Password, Instr

		SET MATERIAL TYPES
The Keystroke sequence to set			TYPES	is:
Press: *	Display will		say:	(PASSWORD)
Press: 22222	Display will		say:	(P		x)
Press: *	Display will		say:	(INSTR --)
Press: 14	Display will		say:	(1TY= OFF)
	The "1"	is	the component			(device) number.
	This is	component 1.			It	will control Hopper 1.

Press: CE repeatedly to select one of the four options. Display will say: (1TY= REG). (Regrind)

(1TY= NAT). (Natural)

(1TY= ADD). (Additive) (1TY= OFF). (turned off)

When the selection you want is displayed, move on to NEXT component:

Press: * Display will say: (2TY= OFF)

REPEAT the "* CE" sequence for ALL components you use.

The * key will walk you through all components.

The CE key will change the TYPE for a component.

Components NOT CONNECTED, or NEVER USED, set to OFF.

When done:
Press:	EXIT	Display	will	say:	(P	x)
Press:	EXIT	Display	will	say:	(	x)

After EXIT, if display says (NEED NAT) then you have specified an ADDITIVE without specifying a NATURAL. This is unacceptable.

NOTE: FOUR dispense valve systems use components 1 through 4. TWO dispense valve systems use 1 and 2.

SIX dispense valve systems use 1 through 4, then 7 and 8. Panel front OUTLETS are always components 5 and 6. Additional outlets are generally components 7 and 8.

+	-----------------------------------------------------			+
¦				¦
¦	PROCEED TO:	RATE CALIBRATION	NEXT PAGE	¦
¦				¦
+	-----------------------------------------------------			+

Page 18