Conair GB DS1 00000 Thumbwheel switch override setting DS2, Extrusion control, Rate of, change of

This parameter is the time that the sensor must be uncovered before a cycle will begin.

PRC 00010 Maximum allowable PERCENT rate change per cycle.

This prevents excessive swings in flow rates by the software. Do not change.

STL 00122 Dispense settle TIME before a weight reading is taken.

The time (interrupts) allowed for material to SETTLE in the weigh bin before a weight is taken. Lengthen only to slow the next cycle start, thereby lowering the pile of material in the mix chamber, and, in some cases, improving mixing.

LCL 00080 LOAD CELL limits, low slope, high slope, frequency, zero.

LCH 00120 DO NOT CHANGE except for different weight load cells. LCF 00079

LCZ 00583

The above 4 parameters relate to the characteristics of the LOAD CELLS on your blender. DO NOT CHANGE THEM.

DS1 00000 Thumbwheel switch override setting.

DS2 00000

The above 2 parameters allow external computer inputs to alter the thumbwheel switch settings. They are used on computer controlled dispense systems, using MLAN software.

XCV 00000	Extrusion control		voltage output value
XRC 00001	Rate of	change of	above value
TCV 00000	Takeoff	equipment	voltage output value
TRC 00004	Rate of	change of	above value
XTP 50050	Trip point to force a correction
XAL 00005	Percentage adjustment limit
XUL 00200	Voltage	adjustment limit

The above 7 parameters all relate to Extrusion Control Systems.

MPO 00010 For air drive reciprocating mix motor.

MCT 00000 Monitor Cycle Time

Alarms if normal cycle timing exceeds previous cycle time by a specified amount. Used to detect mechanical failures.

COMPONENT		PARAMETERS	(12 Groups of	13 parameters each)
The first		digit is the	component number.		Component 1 is shown here.
There	are	11 more just	like it.
1TY =	OFF	DESIGNATES	MATERIAL TYPE	for	this component.
	Material types are: REG, NAT, ADD,				or OFF=NOT USED.
		(0=OFF, 1=REG, 2=NAT, 3=ADD)
	These MUST be set using the *14 function before the system will
			Page	50