Conair GB Part, Printed Outputs, Monitoring, System Accuracy, Cycle Printout Information, Press

+	---------------------------------------------------------------------		+
¦	PART III -	PRINTED OUTPUTS	¦
+	---------------------------------------------------------------------		+
	MONITORING	SYSTEM ACCURACY

*54 - CYCLE PRINTOUT INFORMATION

The best way to monitor system accuracy is to connect a printer to the printer port and turn the printer flag ON (KEYPAD section, *54). The printer will then automatically print full output information after every cycle.

When the printer flag is ON, the controller will output a single heading line at the top of each page and 4 information lines to the printer at the end of each cycle. This adds several seconds to each cycle time. To turn the printer flag on:

Press:	*	Display will say:	(PASSWORD)
Press:	22222	Display will say:	(P	x)
Press:	*54	Display will say:	(PRNT OFF)
Press:	*	Display will say:	(PRNT	ON)
Press:	EXIT	Display will say:	(P	x)
	EXIT	Display will say:	(	x)

Any common parallel printer that you would use with a small PC computer may be used. Connect using a standard parallel printer connecting cable, (34 pin parallel Centronix connector to a DB25 IBM compatible connector), available from us or at any computer store.

INTERPRETING the *54 CYCLE PRINTOUT

10 or 20 cycles of data can tell a lot about the performance of your blender. The following will help you interpret the data.

A single	cycle	printout looks		like this:
	(dashes ---- added for clarity of					spacing)
	------------		------------		------------		------------		------
	**1 R	20.0**	**2 N	100**	**3 A	04.0**	**4 A 00.0**		TOTAL
* 11/10/97 *	* 16:17:53 *		RECIPE	0000	**ID#	051**	**WO 000000*		OPR000
FINAL: DISP,%	0.0	.0	1908.3		77.6	4.06	0.0	.00	2000.1
RATE: GR/TIME	18224	976	19993	488	12973	31232	10240 31232		9.9
1ST DISP,TIME	0.0	00	1908.3	469	77.6	1826	0.0	00	22

DEFINITION OF EACH LINE

The TOP-OF-PAGE heading:
------------ ------------	------------	------------	------
**1 R 20.0** **2 N 100**	**3 A 04.0**	**4 A 00.0**	TOTAL

Prints as a heading to each page, or once every 10 cycles. This serves as a heading over four columns of material. Additional lines will

Page 74