EXIT will exit the sequence at any point, Exit, Exit any, Seconds

Press once to display the current Work Order number (WO-----). Press again to display the current Operator

number (OPRTR---). Press again for the Recipe (RECP ---). You may enter or change the Work Order or Operator number, when each is displayed, but not the recipe number.

These numbers are for your TRACKING of information ONLY. They have NO EFFECT on the operation of the Weigh Scale Blender.

WORK ORDER number (6 digits) allows you to tag all information with an internal accounting number such as a job or purchase order number.

OPERATOR number (3 digits) allows you to track who is operating the equipment.

RECIPE number (3 digits) allows you to track what recipe you are using but you can not enter or change it here. The number will be a 2 digit number if a recipe is being run that resides in the controller RAM; one that was entered using the RECIPE key. If a recipe has been entered using our MLAN software, through the computer port, then a 3 digit number will be displayed. In either case, the number in this field will be displayed and "tagged" to all printouts and retrievals.

EXIT will exit the sequence at any point.

EXIT:	This key is operational in ALL MODES.
	Use the EXIT key to		exit any	and all keypad sequences.
CE:	Press "CE"	at any time to display raw			data readout of the
	load cells	for five	seconds.	This is	helpful in diagnosing

possible load cell problems and is explained in detail in the MAINTENANCE section.

"CE" is used frequently in connection with other keys, to clear or scan through selections.

KEYPAD - MANUAL MODE

In this mode, you may operate individual functions manually for test purposes. No totals are saved and automatic operation does not take place. The low level sensor has no control or effect over manual operation requests.

The Row of keys marked OPER, TIME, VER, and CAL operate in this mode coupled with all device keys; 1 through 9, A, B, C, DUMP, MIX, HOLD, and ALRM.

You can enter this	mode only	when	the controller is between cycles.
The sensor must be	covered or the		STOP switch must be in the "STOP -END
OF CYCLE" position.	When in	this	mode, no automatic dispensing occurs.

To enter this mode, press "*", then enter the correct password number. The password supplied with the unit is "11111." You may change this to

Page 34

Conair GB EXIT will exit the sequence at any point, Exit, This key is operational in ALL MODES

Models: GB WSB

EXIT will exit the sequence at any point.

This key is operational in ALL MODES.

Use the EXIT key to

exit any

and all keypad sequences.

Press "CE"

at any time to display raw

data readout of the

load cells

for five

seconds.

helpful in diagnosing

KEYPAD - MANUAL MODE

You can enter this

mode only

the controller is between cycles.

The sensor must be

covered or the

STOP switch must be in the "STOP -END

OF CYCLE" position.

When in

this

mode, no automatic dispensing occurs.