Conair WSB, GB STAR FUNCTIONS available in this mode, Press *,0,2 to turn on, Extrusion, flag to

STAR FUNCTIONS available in this mode:

*02 This flag for EXTRUSION and YIELD control, and RATE display.

Press (*,0,2) to turn on		Extrusion	or Yield control.
The default display is	(	OFF).
Press * to toggle this	flag to (		RATE ), (EXT CTRL), or
(YLD CTRL).

If you are using our EXTRUSION or YIELD control software to control your extruder, refer to our EXTRUSION CONTROL instruction booklet for complete information.

If you simply want to view throughput continuously on the blender display, set this option to ( RATE ). This will alter the display only. In all other respects, the blender will operate normally.

*03 Press (*,0,3) to allow four digit entry of settings in the format (xx.xx). This does not make the blender more accurate. It does allow easier setup for customers that have a mixture of setting requirements, that is x.xx entry requirements as well as the standard xx.x requirements. Normally the XT parameter would be manually adjusted to allow the decimal shift. If this four digit entry option is turned on, then all entries are in the format xx.xx. The software uses only the first three digits unless the first digit is a zero, in which case the last three digits are selected and the related XT parameter is set to 00010. See XT parameter for more information. Display will say (SET= XXX) or (SET=XXXX). Use * key to toggle.

*04 Press (*,0,4) to select from 4 standard software configurations. If you want your unit to look and act like it is running FOUR software, then this option will do this for you in one easy step.

Use the "*" key to toggle through			all selections.
Select ( KEYPAD )	to exit without		changing anything.
Select ( R,N,C,A)	for system	to operate like FOUR software.
Select ( N,N,C,A)	to operate	like	FOUR software with	the
	"TWO NATURALS" flag on.
Select ( N,N,N,A)	to operate	with	three Naturals and	an
	additive.
Select ( R,N,N,A)	to operate	with	Regrind, two Naturals,

and an additive.

Component 2 is ALWAYS a NATURAL, and is never assigned a thumbwheel switch. Components 1, 3, and 4 are always assigned to thumbwheel switches.

If ( R,N,C,A) is selected, component 2 is the ONLY natural and is set to 100.

If ( N,N,C,A), ( N,N,N,A), or (R,N,N,A) is selected, the first, third, and forth components are assigned to switches 3, 1, and 2 respectively. Component 2 setting will be adjusted automatically at the start of each cycle to a

Page 39