Conair GB, WSB detailed explanation of these printouts, COMPUTER input / output, Internal Fuses

detailed explanation of these printouts.

16.COMPUTER input / output

If you choose to gather material usage data automatically and continuously by computer, then this connector allows for connection to any IBM PC type computer operating under MS-DOS or WINDOWS.

The COMPUTER port is a DB9 (9 pin) male port. You will need a specially wired cable from us to connect to the serial port on your standard PC computer. Your computer operating system must be MS-DOS or WINDOWS. You will need software from us for communicating with your Autoweigh Blender. This software allows downloading settings and retrieval of information and produces reports for those customers who wish to take advantage of this feature. Either one or many Weigh Scale Blenders can be connected to one computer. For multiple Weigh Scale Blender systems, or communication over long distances, an additional piece of hardware is required. All GB/WSB controllers are fully programmed to communicate with your computer now or at a later date.

17.PANEL FUSE for duplex receptacle - 3 amp

Fuses the common power wire of the duplex receptacle (the color and additive outputs). Since these outlets are only turned on one at a time, each is protected to the full 3 amp rating of the fuse.

18.PANEL FUSE for processor - 1/2 amp

Fuses power to the circuit board power supply which includes all solenoid outputs and solid state relay outputs.

19.INTERNAL FUSES

An in-line fuse is provided internally to protect the main 120 volt power cord supply (10) amps. If this fuses blow, an internal short circuit is indicated and we don't recommend that you try to fix it.

Remember, this unit carries a three year warranty; just send it back.

The MIX MOTOR timed power source and the AUGER FEEDER OUTLETS are driven by internal solid state plug-in relays. These relays are located on the circuit board mounted on the inside back surface of the controller enclosure. A small 5 amp glass fuse is located to the right of each relay. A spare fuse is also located on the board if replacement is necessary.

20.THUMBWHEEL SWITCHES

The three sets of THUMBWHEEL switches have no effect unless they are assigned to a particular output device. Entry of all SETTINGS is done by using the KEYPAD. However, if you prefer, you may assign up to three components to the Thumbwheel switches and then use these switches to set and alter their settings.

Since only three switch sets are available, only 3 components can be controlled in this manner. All others must use the keypad.

See ENTERING SETTINGS for more information on how to do this.

21.KEYPAD: Explained in next section, next page. Page 28