Conair GB Entering, Settings, Press, Display will say, xx.x, Regrind, Natural, Additive, Exit

		ENTERING	SETTINGS
Press:	SET	Display will say	(1 R		xx.x)	(Regrind)
		or	(1	N	xxx)	(Natural)
		or	(1	A	xx.x)	(Additive)

1 is Component number. R,N,A is Type.

xx.x is Setting.

Enter a 3 digit setting:
		Regrind settings	= PERCENTAGE of the		ENTIRE MIX
		Natural settings	= RATIO to	OTHER NATURAL SETTINGS
		Additive settings = PERCENTAGE of ALL			the NATURALS
Press:	SET	for the NEXT setting.
		Repeat this sequence for all		components.
Press:	EXIT	when finished.
When entering settings, remember:
Panel front OUTLETS are always components 5 and				6; (left	and right).
If only one natural is present, any number will				do for a	setting.
Any component set to zero will not dispense.

THUMBWHEEL ASSIGNMENTS - THIS IS OPTIONAL

You may assign a component to one of the three thumbwheel switches. You might do this for components that you wish to change settings frequently. This is ENTIRELY OPTIONAL.

TO DO SO:
Press:	SET	Display		will say (1 R xx.x)
Press:	A	Display		will say (1 R TW 1)	(Thumbwheel 1)
or	B	Display		will say (1 R TW 2)	(Thumbwheel 2)
or	C	Display		will say (1 R TW 3)	(Thumbwheel 3)
		1	= TOP	switches,
		2	= MIDDLE switches,
		3	= BOTTOM switches.

To RETURN component to KEYPAD entry of the setting:

Press:	CE	Display will return to (1 R 00.0)
Press:	EXIT	when finished.

Page 20