Conair WSB recipe. Display = GET, Display will flash through this recipe data, Batch, Btch, full

recipe. Display = (GET --).

If no RECIPE is currently in use, display says (GET --). Enter 2 digits to retrieve one of 50 recipes.

Display will flash through this recipe data:

(RCP 01), (1R= xx ), (2N= xx.x), etc., (* = LOAD)

Press "*" to LOAD this recipe into memory. Routine will exit automatically. Press RCP or EXIT to return to the display (GET --). Press RCP or EXIT again to exit.

To SAVE a RECIPE you must be in the PROGRAM mode.

If you press RCP key again after display of (GET --), display says (SAVE --). Enter 2 digits, display will say (SAVING ). The current settings are saved into memory under the recipe number you have entered.

Routine will EXIT automatically.

EXIT will exit at any time.

To clear a recipe, set all component settings to zero and save these settings into the recipe location.

BATCH:	This key allows you to blend a PRE-SELECTED WEIGHT of
(BTCH)	material,	and then STOP running and sound the ALARM.	The
	process may also be programmed to sound the alarm but
	continue running. Since each cycle will always blend a			full
	weigh bin	amount, the total amount blended may exceed the
	target batch weight by up to one cycle's blend weight.
	This key is NOT FUNCTIONAL unless the last digit in the
	"FLG" parameter is set to 1 or 2. (xxxx1 or xxxx2).		To	do
	this, see	the MAINTENANCE section, PARAMETER TABLE, "FLG".
	The ALARM	SILENCE button on the side of the controller,		is
	the ONLY way to CONTINUE OPERATION after a BATCH amount			has
	been run.

Assuming a proper "FLG" parameter is set:

Press the BTCH key once to view the desired BATCH WEIGHT. Display will say (BW #####).

BATCH WEIGHT is the amount you wish to dispense before stopping and/or sounding the alarm.

Press again to view the CURRENT PORTION, of the batch, that has been dispensed.

Display will say (CP #####).

CURRENT PORTION shows how much of the Batch Weight you have blended so far.

Press again to view the ACCUMULATED TOTAL weight of all batches dispensed.

Display will say (AT #####).

ACCUMULATED TOTAL is the sum weight of all batches that have been blended. This number will continue to grow until it is manually cleared to zero, or it exceeds its maximum possible value.

Page 31