D-Link DES-3010FA/GA manual Click . The Rstp Settings Page opens

D-Link DES-3010FA/GA User Guide

•Mode—Displays the current STP mode. The STP mode is selected in the STP Properties Page. The possible field values are:

–STP — Classic STP is enabled on the device.

–Rapid STP — Rapid STP is enabled on the device.

–Multiple STP — Multiple STP is enabled on the device.

•Fast Link Operational Status — Indicates whether Fast Link is enabled or disabled for the port or LAG. If Fast Link is enabled for a port, the port is automatically placed in the forwarding state.

•Port Status — Displays the RSTP status for the port on which RSTP is enabled. The possible field values are:

–Disable — indicates the port is currently disabled.

–Forwarding — Indicates the port is currenlty linked and forwarding traffic.

•Point-to-Point Admin Status — Indicates whether a point-to-point link is established, or if the device is per- mitted to establish a point-to-point link. The possible field values are:

–Enable — The device is permitted to establish a point-to-point link, or is configured to automatically establish a point-to-point link. To establish communications over a point-to-point link, the originating PPP first sends Link Control Protocol (LCP) packets to configure and test the data link. After a link is established and optional facilities are negotiated as needed by the LCP, the originating PPP sends Network Control Protocol (NCP) packets to select and configure one or more network layer protocols. When each of the chosen network layer protocols has been configured, packets from each network layer protocol can be sent over the link. The link remains configured for communications until explicit LCP or NCP packets close the link, or until some external event occurs. This is the actual switch port link type. It may differ from the administrative state.

–Disable — Disables point-to-point link.

•Point-to-Point Operational Status — Displays the point-to-point operating state.

•Activate Protocol Migration — Indicates whether sending Link Control Protocol (LCP) packets to configure and test the data link is enabled. The possible field values are:

–Checked — Protocol Migration is enabled.

–Unchecked — Protocol Migration is disabled.

2.Click . The RSTP Settings Page opens:

Page 146