D-Link DES-3010FA/GA manual Startup Procedures, Startup Menu Procedures

Starting and Configuring the Device

Startup Procedures

Startup Procedures

This section includes the following topics:

•Startup Menu Procedures

•Software Download and Reboot

Startup Menu Procedures

The procedures called from the Startup menu cover software download, flash handling, and password recovery. The diagnostics procedures are for use by technical support personnel only and are not disclosed in this document.

The Startup menu can be entered when booting the device. A user input must be entered immediately after the POST test.

To enter the Startup menu:

1.Turn the power on and watch for the auto-boot message.

This command will reset the whole system and disconnect your current session. Do you want to continue (y/n) [n] ?

y

**************************************************

***************** SYSTEM RESET *****************

**************************************************

------ Performing the Power-On Self Test (POST) ------

UART Channel Loopback Test............PASS Testing the System SDRAM.............PASS I2C Bus Test.........................PASS Boot1 Checksum Test................PASS Boot2 Checksum Test................PASS Flash Image Validation Test............PASS

BOOT Software Version 1.0.0.11 Built 10-Apr-2005 13:25:46

DES3010 D-LINK board - based on Samsung S3C2510A ARM940T processor.

32 MByte SDRAM. I-Cache 4 KB. D-Cache 4 KB. Cache Enabled.

Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.

2.When the auto-boot message appears, press <Enter> to display the Startup menu. The Startup menu procedures can be done using the ASCII terminal or Windows HyperTerminal.

[1]Download Software

[2]Erase Flash File

[3]Erase Flash Sectors

[4]Password Recovery Procedure

[5]Enter Diagnostic Mode

[6]Back

Enter your choice or press 'ESC' to exit:Enter your choice or press 'ESC' to exit:

The following sections describe the available Startup menu options.

Page 43