diskette/tape drive interface cable

DC power cable

Ultra/Wide

SCSI cable

diskette/tape drive

interface connector (FLOPPY)

Ultra/Wide SCSI host adapter connector (SCSI B)

Figure 9-1. External Drive Bay Hardware

Before You Begin

This chapter describes how to install the following options:

Drives that use the computer’s built-in diskette drive controller.

Tape drives that use a controller card

NOTE: If you are installing a SCSI hard-disk drive, see Chapter 10, “Installing Drives in the Internal Bays.”

diskette drive

SCSI CD-ROM drive

DC power cable

To remove or install drives in the external bays, you must remove both computer covers and front bezel according to the instructions in “Removing the Computer Covers” and “Removing the Front Bezel” in Chapter 7.

To protect the inside of the computer from foreign par- ticles, a plastic front-panel insert covers each empty external drive bay. Before you install a drive in an empty bay, you must first remove the front-panel insert.

Whenever you remove a drive, be sure to replace the front-panel insert over the empty bay.

9-2 Dell PowerEdge 6100/200 System Installation and Troubleshooting Guide

Page 96
Image 96
Dell 200, 6100 manual Before You Begin, External Drive Bay Hardware