Recommended tools, Front bezel optional

For more information, see Installing the system cover.

2.Place the system upright on its feet on a flat, stable surface.

3.Install the optional bezel.

For more information, see Installing the front bezel.

4.Reconnect the system to its electrical outlet and peripherals.

5.Turn the system on, including any attached peripherals.

Recommended tools

You need the #2 Phillips screwdriver to perform the removal and installation procedures.

The following tools are required for assembling cables for a DC power supply unit (PSU):

•AMP 90871-1 hand-crimping tool or equivalent

•Tyco Electronics 58433-3 or equivalent

•Wire-stripper pliers capable of removing insulation from size 10 AWG solid or stranded, insulated copper wire

NOTE: Use alpha wire part number 3080 or equivalent (65/30 stranding).

1.Locate and remove the bezel keys.

2.Insert the bezel tabs into the bezel tab slots in the chassis.

3.Insert the bezel tabs into the slots on the chassis.

4.Press the release latch and push the bezel toward the system until the bezel locks into place.

5.Lock the bezel.