Steps
1.Locate the internal dual SD module on the system board.
2.If installed, remove the SD card(s).
3.Hold the plastic pull tab and pull the dual SD module out of the chassis.
Figure 33. Removing and installing the Internal Dual SD Module (IDSDM)
1. | Internal Dual SD module | 2. | LED status indicator (2) |
3. | SD card (2) | 4. | SD card slot 2 |
5. | SD card slot 1 | 6. | IDSDM connector |
The following table describes the IDSDM indicator codes.
Convention | IDSDM indicator code | Description |
|
|
|
A | Green | Indicates that the card is online |
B | Flashing green | Indicates rebuild or activity |
95
