NOTE:

®,HDCD®, High Definition Compactible Dgital® and Pacific MicrosonicsTM are either registered trademarks or trademarks of Pacific Microsonics, Inc. in the United States and/or other countries. HDCD system manufactured under license from Pacific Microsonics, Inc. This product is covered by one or more of the following: In the USA: 5,479,168, 5,683,074, 5,640,161, 5,808,574, 5,838,274, 5,854,600, 5,864,311, 5,872,531, and in Australia: 669114. Other patents pending.

ENGLISH

6REMOTE CONTROL UNIT

2The DVD-2800 can be controlled from a distance using the included remote control unit (RC-546).

(1) Inserting Batteries

qRemove the remote control unit’s rear cover.

Cautions On Batteries

• Use R03/AAA batteries in this remote control unit.

• Replace the batteries with new ones approximately once

a year, though this depends on the frequency with which

the remote control unit is used.

• If the remote control unit does not operate from close to

the main unit, replace the batteries with new ones, even

(2) Rear Panel

!6 Audio output connectors (AUDIO OUT) !7 Digital audio output connector (OPTICAL)

•Connect using an optical fiber cable (available in stores).

•Digital data is output from this connector.

!8 Digital audio output connector (COAXIAL)

•Connect using an audio cord. Connect a commercially available 75 Ω/ohms pin-plug cord.

•Connect using the included audio video cord.

!9 Video output connector (VIDEO OUT)

•Connect using the included audio video cord.

@0 S-Video output connector (S-VIDEO OUT)

•Connect using an S-Video connection cord (available in stores).

@1 Component video output connectors

(COMPONENT)

• Connect using video cords (available in stores).

@2 21-pin SCART terminal (AV 1) (For only European model)

•Connect using a 21-pin SCART cable (available in stores).

@3 Control input connector (ROOM TO ROOM / IN)

•This is the input connector for wired remote control. Consult your DENON dealer if you wish to use this connector.

@4 Control output connector

(ROOM TO ROOM / OUT)

•This is the output connector for wired remote control. Consult your DENON dealer if you wish to use this connector.

@5 Power input (AC IN)

• Connect to AC power supply using the included AC cord.

wPlace two R03/AAA batteries in the battery compartment in the direction indicated by the marks.

eClose the rear cover.

if less than a year has passed.

• The included battery is only for verifying operation.

Replace it with a new battery as soon as possible.

• When inserting the batteries, be careful to do so in the

proper direction, following the < and > marks in the

remote control unit’s battery compartment.

• To prevent damage or battery fluid leakage:

• Do not use a new battery with an old one.

• Do not use two different types of batteries.

• Do not short-circuit, disassemble, heat or dispose of

batteries in flames.

• Remove the batteries when not planning to use the

remote control unit for a long period of time.

• If the batteries should leak, carefully wipe off the fluid

from the inside of the battery compartment, then insert

new batteries.

(3) Display

Lights during playback, flashes when the resume play memory function is activated.

Lights in the repeat play mode.

 

 

 

Lights in the still/pause mode.

 

 

 

 

 

 

 

 

 

 

 

 

ANGLE

 

DVD PROG.

96kHz 24bit

 

 

 

The title and elapsed track time are

 

 

 

displayed here during playback.

The title/chapter number is displayed here for

DVDs, the track number for video and music CDs.

Lights during playback of 24-bit linear PCM sound.

Lights during playback of linear PCM sound with a sampling frequency of 96 kHz.

(2) Using the Remote Control Unit

Approx. 7 meters

30°

30°

•When operating the remote control unit, point it at the remote control sensor as shown on the diagram.

•The remote control unit can be used from a direct distance of approximately 7 meters. This distance will be shorter, however, if there are obstacles in the way or if the remote control unit is not pointed directly at the remote control sensor.

•The remote control unit can be operated at a horizontal angle of up to 30° with respect to the remote control sensor.

Lights in the programmed play mode.

Lights during playback of multiple angles discs.

Lights when a DVD is loaded in the disc tray.

NOTES:

•It may be difficult to operate the remote control unit if the remote control sensor is exposed to direct sunlight or strong artificial light.

•Do not press buttons on the main unit and on the remote control unit at the same time. Doing so will result in malfunction.

9