Digicom 3911, 3910 Set Access Ctrl SetOrigSec, Set Originate Security Group Options

COMSPHERE 3900 Series Modems

Set Orig Sec

Set Originate Security controls whether or not the modem can originate a call using AT commands when the dial access security feature is installed. This method of outbound security only applies to modems originating a call.

To access Set Orig Sec from Set Access Ctrl, make the following selections:

Set Access Ctrl

Set_Orig_Sec

F1 F2 F3

Press the key until Set_Orig_Sec appears.

Select Set_Orig_Sec.

Table 12-3 describes the settings of the Set Originate Security group option.

Table 12-3

Set Originate Security Group Options

Set Orig Sec

No_OrigSec EnaOrigSec

Set Originate Security. Controls the security protection for origination of calls when AT commands are used.

NOTE: The originate password must be included in all AT dial command strings if this option is enabled. If not included, or incorrectly entered, the message ERROR is returned to the DTE.

HNo Originate Security

Disables originate security so that a modem can originate a call using AT commands.

HEnable Originate Security

When using AT commands, the modem will only place a call if a valid password is entered along with an AT dial command. If the password is not entered, then ERROR is returned to the DTE, and the dial command is canceled.

12-10 September 1998 3910-A2-GN32-40