Digicom 3910, 3911 operation manual = Ascii = Ebcdic

AT Command Set and S-Registers

Table 14-3

(7 of 13)

391x Series S-Registers

S-Register		Description	DCP LCD
			Command
			Sequence
S61	CT111 Rate Control. Register determines if CT111 Rate is disabled,		Configure\Edit\
	set for Fallback 1 or Fallback 2.		DTE Interface
	CT111 Rate allows the DTE to control modem rate via Pin 23 of the
	EIA-232-D interface. This configuration option determines the effect of
	the DTE Rate Control signal. It is only valid in Async Direct mode and
	Synchronous mode. For proper operation, disable the V.32bis Autorate
	and V.32bis Automode configuration options.
	Register has the following values:
	0	= Disable
	1	= Fallback
	2	= Fallback 2
	The factory setting is Disable.
S62	V.25bis Coding. Register identifies to the modem the type of coding		Configure\Edit\
	used by the DTE while in V.25bis mode.		DTE Dialer
	Register has the following values:
	0	= ASCII
	1	= EBCDIC
	The factory setting is ASCII.
S63	V.25bis Idle Character. Register identifies to the modem the type of		Configure\Edit\
	idle fill used by the DTE while in V.25bis mode.		DTE Dialer
	Register has the following values:
	0	= Mark
	1	= Flag
	The factory setting is Mark.
S64	V.25bis New Line Character. Register identifies to the modem the type		Configure\Edit\
	of line terminator used by the DTE while in V.25bis mode.		DTE Dialer
	Register has the following values:
	0	=Carriage Return and Line Feed
	1	=Carriage Return
	2	=Line Feed
	The factory setting is carriage return and line feed (CR + LF).
S65	Line Current Disconnect. Register determines if the modem		Configure\Edit\
	disconnects if an 8-millisecond or 90-millisecond interruption in loop		Line Dialer
	current occurs.
	Register has the following values:
	0	= Enable (8msec)
	1	= Enable (90msec)
	2	= Disable
	The factory setting is Enable (8msec).

3910-A2-GN32-40 September 1998 14-21