Digicom 3911, 3910 operation manual 14-16

COMSPHERE 3900 Series Modems

Table 14-3

(2 of 13)

391x Series S-Registers

S-Register	Description	DCP LCD
		Command
		Sequence
S5	Backspace Character. Register determines ASCII value used as the	Configure\Edit\
	backspace (Backspace key). This character moves the cursor to the	DTE Dialer
	left and erases the previous character.
	Enter a value from 0–127. The factory setting is 8 (backspace key).
S6	Blind Dial Pause1. Register determines how long (in seconds) the	Configure\Edit\
	modem waits after going off-hook before dialing a telephone number if	Line Dialer
	using result code X0, X1, or X3.
	Enter a value from 2–255 seconds. The factory setting is 2.
S7	No Answer Time-out1. Register determines how long (in seconds) an	Configure\Edit\
	originating modem waits before abandoning a call when no answer	Line Dialer
	tone is received.
	Enter a value from 1–255 seconds. The factory setting is 45.
S8	“,” Pause Time for the Dial Modifier. Register determines how long (in	Configure\Edit\
	seconds) the modem pauses when it encounters a comma (,) in the	Line Dialer
	Dial command string.
	Enter a value from 0–255 seconds. The factory setting is 2.
S10	No Carrier Disconnect1. Register determines how long (in tenths of	Configure\Edit\
	seconds) the modem allows the carrier signal to be OFF before	Line Dialer
	disconnecting the call.
	Enter a value from 0–254 in 0.1 second increments. A value of 255
	disables this register. The factory setting is 20 (2 seconds).
S12	Escape Guard Time. Register sets the value (in 20-millisecond	Configure\Edit\
	increments) for the required pause before and after the escape	DTE Dialer
	sequence is issued. The guard time prevents the modem from
	interpreting data as the escape sequence characters.
	Enter a value from 0–255 in 20-millisecond increments. The factory
	setting of 50 equals 1000 milliseconds or one second.
S18	Test Time-out. Register sets the duration (in seconds) for the modem	Configure\Edit\
	tests. This automatically cancels any test in progress after the time of	Tests
	this register expires. Any test can be manually canceled by issuing the
	escape sequence (+++) followed by the &T0 command.
	Enter a value from 0–255 seconds. A value of 0 disables this register.
	The factory setting is Disable (0).
S26	RTS-to-CTS Delay. Register sets the length of time (in 10-millisecond	Configure\Edit\
	increments) the modem waits after receiving RTS before issuing CTS	DTE Interface
	to the DTE.
	Enter a value from 0–255. The factory setting is 0.

1 The range of allowable values may be restricted in some countries.

14-16 September 1998 3910-A2-GN32-40