Digicom 3911, 3910 Common Operational Messages, Common Indicates Operational Message

COMSPHERE 3900 Series Modems

Messages listed in Table 3-4 are common operational messages that occur during modem operation. These messages normally appear on the second line of the LCD.

	Table 3-4
	Common Operational Messages
Common	Indicates
Operational Message
Please Wait...	A command to a local device takes more than two seconds to complete.
Command Sent...	A command is sent to a remote modem.
No Rem Response or	A remote modem does not respond to a command within 5 seconds.
Remote Modem Fail
Command Complete	A command, issued to a local or remote modem, is completed.
Invalid Command	The modem cannot complete a command.

Messages listed in Table 3-5 are dial access security messages.

	Table 3-5
	Dial Access Security Messages
Dial Access Security	Indicates
Message
Get VF PsWd	The answering modem is waiting for the originating caller to transmit a VF
	password.
Get DTE PsWd	The answering modem is waiting to receive a valid DTE password from the
	remote DTE.
VF PsWd Timeout	The modem did not finish answering a call (disconnected) because the allowed
	time limit was exceeded before the modem received a VF password from the
	originating dialer.
Unknown DTEpswd	The modem did not finish answering a call (disconnected) because the DTE
	passwords received from the remote DTE were invalid.
No Orig PsWd	The modem did not attempt to establish a call as requested because the AT dial
	command did not contain an originate access password.
Unknown VF PsWd	The modem did not finish answering a call (disconnected) because the modem
	received an invalid VF password.
DTEpswd Timeout	The modem did not finish answering a call (disconnected) because the allowed
	time limit was exceeded before the modem received a DTE password from the
	remote DTE.
Inval Orig PsWd	The modem did not attempt to establish the call as requested because the
	originate password in the AT dial command was not valid.
DTR Dial Blockd	DTR dialing is not permitted when security is enabled. This message appears if
	DTR dialing is used and Answer Access or Originate Access security is
	enabled.
SecurityBlocked	The access verification capabilities are not available and the modem does not
	pass data to the DTE under any circumstances. This message appears only
	when the modem is in base mode (a mode that occurs during a firmware
	download) and Answer Access Security is enabled.

3-12 September 1998 3910-A2-GN32-40