Digicom 3910, 3911 operation manual AT Escape Char 043 Asci Nxt 043 Asci

DCP Configuration

Table 5-2

(2 of 5)

DTE Dialer Configuration Options

AT Escape Char: 043 ASCI

Nxt " 043 ASCI

This configuration option only appears if DTE Dialer Type is configured for AT.

AT Escape Character. The escape sequence (+++) allows you to move from Data mode to Command mode. Use the AT Originate (ATO) command to return to Data mode. The ASCII value of the escape character (43 ASCII) can be set to any ASCII value from 0 ASCII to 255 ASCII. However, the escape character is disabled if a value greater than 127 ASCII is entered. When disabled, the call must be disconnected to return to Command mode.

The AT command is S-Register S2=n, where n is a value from 0 to 127.

The AT command to disable is S-Register S2=n where n is a value from 128 to 255. (When disabled, the modem cannot return to Command mode unless disconnected.)

Escape GuardTim: 1sec

Nxt 1sec 200msec 400msec 600msec 800msec 2sec

This configuration option only appears if DTE Dialer Type is configured for AT.

Escape Guard Time. Determines the length of the required pause before and after the escape sequence is issued. The guard time prevents the modem from interpreting data as the escape sequence characters.

The AT command is S-Register S12=n, where n is a value from 0 to 255 in 20 millisecond increments.

BreakForceEscap: Disable

Nxt Disable Enable

This configuration option only appears if DTE Dialer Type is configured for AT.

Break Forces Escape. Determines whether or not the modem should enter Command mode when it receives a break character from the DTE.

HDisable

A break character is sent to the remote end.

HEnable

Modem escapes into AT Command mode, and a break character is not sent to the remote end.

The AT commands for Enable are \K0, \K2, or \K4.

The AT commands for Disable are \K1, \K3, or \K5.

CommandCharEcho: Enable

Nxt Enable Disable

This configuration option only appears if DTE Dialer Type is configured for AT.

Command Character Echo. Controls whether or not characters are echoed back to the DTE when the modem is in Command mode.

The AT command for Disable is E0.

The AT command for Enable is E1.

3910-A2-GN32-40 September 1998 5-21