Digicom 3911, 3910 operation manual Blind Dial Pause 2sec Nxt 2sec 4sec 6sec 8sec 10sec 20sec

COMSPHERE 3900 Series Modems

Table 5-3

(2 of 5)

Line Dialer Configuration Options

Blind Dial Pause: 2sec

Nxt 2sec 4sec 6sec 8sec 10sec 20sec

This configuration option only appears when Dial Tone Detect is configured for Disable.

Blind Dial Pause. Determines how long the modem waits before dialing a telephone number when Dialtone Detect is disabled.

NOTE: The range of allowable values may be restricted in some countries.

The AT command is S-Register S6=n, where n is from 2 to 255 in 1-second increments.

BusyTone Detect: Enable

Nxt Enable Disable

Busy Tone Detect. Sets the modem to monitor for Busy Tone (Enable) or ignore Busy Tone (Disable).

NOTE: This configuration option is normally enabled; however, if the modem receives false busy tones, this configuration option can be disabled and the modem ignores all busy tones.

The AT commands for Disable are X0, X1, and X2.

The AT commands for Enable are X3, X4, X5, X6, and X7.

“,” Pause Time: 2sec

Nxt 2sec 4sec 6sec 8sec 10sec 20sec

Pause Time. Determines the number of seconds the modem pauses when it encounters a comma (,) in the dial command string.

NOTE: Although DCP selections are limited (2, 4, 6, 8, 10, or 20), values set by the AT commands can display from 0 to 255 seconds.

The AT command is S-Register S8=n, where n is from 0 to 255 in 1-second increments.

NoAnswer Timout: 45sec

Nxt 45sec 30sec 60sec 120sec

No Answer Abort Timeout. Determines the number of seconds an originating modem waits before abandoning a call attempt when no answer tone is received.

NOTE: Although DCP selections are limited (30, 45, 60, or 120), values set by AT commands can display from 1 to 255 seconds.

NOTE: The range of allowable values may be restricted in some countries.

The AT command is S-Register S7=n, where n is from 1 to 255 in 1-second increments.

5-26 September 1998 3910-A2-GN32-40