Digicom 3910, 3911 operation manual Diagnostic Control Panel Access, Frnt Panl Acces GrantDeny

Remote Branch

•If a connection is established but the wrong password is stored, the status message Password Invalid appears on the LCD. This configuration option must be enabled by the remote user. (Refer to the Remote Access Password configuration option in Table 5-8 of Chapter 5, DCP Configuration.)

•The Remote mode command displays Other Test Active if an Analog Loopback test is currently running.

Diagnostic Control Panel Access

NOTE

This page of the manual is self supporting and can be removed to prevent unwanted knowledge of the DCP security access selections.

Use the DCP security access function to “lock” the DCP of any 391x Series modem and prevent unwanted user access. Two options are available for this function: Grant and Deny.

Grant allows any branch of the Top-Level menu to be accessed from the DCP. Deny only allows access to the Status branch of the Top-Level menu. All 391x Series modems are shipped from the factory with DCP access granted.

To access the Front Panel (DCP) Security Access function, perform the following:

Press the key three times.

Press the key twice.

Press the key once.

Frnt Panl Acces

GrantDeny

F1 F2 F3

Select Grant to allow access or select Deny to lock DCP access.

Either selection results in a return to the Top-Level menu.

3910-A2-GN32-40 September 1998 13-5