Digicom 3911, 3910 operation manual Miscellaneous Configuration Options

COMSPHERE 3900 Series Modems

Table 5-8

(3 of 4)

Miscellaneous Configuration Options

NMS_Call_Msgs: CallCnct&Prg

Nxt CallCnct&Prg Disable CallCnctOnly CallProgOnly

NMS Call Messages. Determines if the modem status and/or call summary information is sent to the NMS. The modem can itemize status, such as CallProgress messages, or it can report a summary of activity, such as Call Connect messages, to the NMS.

HCall Connect & Progress

Enables both Call Connect and Call Progress information to be transmitted to the NMS.

HDisable

Modem status and call summary information is not sent to the NMS.

HCall Connect Only

The modem accumulates call statistics over a period of time and then transmits a summary of these statistics to the NMS. The NMS uses this data to produce utilization reports.

HCall Progress Only

The modem transmits detailed modem status information to the NMS. These messages include any events that can display on the LCD.

NOTE: For 6800 Series NMS applications, Disable must be selected.

The AT commands are S-Register S66=n where n is 0 for Call Connect & Progress, 1 for Disable, 2 for Call Connect Only, and 3 for Call Progress Only.

NetworkPosition: Tributary

End Tributary Control

Network Position Identification. Each modem must be identified either as a control modem or a tributary modem.

NOTE: Changes to this configuration option will cause the modem to reset.

NOTE: This configuration option is only applicable for leased-line network management applications.

For the Model 3910, Tributary is the factory default.

For the Model 3911, Control is the factory default.

The AT command for Tributary is S74=0.

The AT command for Control is S74=1.

NetMngmtAddress: 256

Nxt " 256

This configuration option is not available in point-to-point tributaries.

Network Management Address. Determines the address used when accessing a modem from the NMS or when using DCP functions that require network management addresses. Within a network link, a control modem can communicate with a tributary modem by using the tributary modem’s network management address. Each tributary modem must have a different network management address.

NOTE: Changes to this configuration option will cause the modem to reset.

NOTE: A point-to-point tributary is always Address 1.

Address values range from 001 to 256.

The AT command is S-Register S75=n, where n is a value from 0 to 255 (001 to 256).

5-50 September 1998 3910-A2-GN32-40