Digicom 3910, 3911 operation manual 12-15

Dial Access Security

Table 12-4

(3 of 3)

Security Configuration Options

HVF & DTE

The answering modem is enabled for security. The modems negotiate security using the VF-side password entry technique protocol. If successful, and the Password Type for this particular VF password is set for VF_&_DTE, a password is requested from the originating user. If successful, the modems connect and can pass data.

NOTE: The settings of this configuration option determine the type of access security protection provided by the modem. It can be disabled using the No_Answ_Sec setting, or it can be enabled with the DTE_Only or VF_&_DTE settings.

Originate_Secur: No_OrigSec

End No_OrigSec Ena_Orig_Sec

Originate Security Mode. This configuration option is read-only and cannot be changed from the Configuration branch. The setting of this configuration option can only be changed in the Set Orig Sec group found in the Security branch.

HNo Originate Security

Disables originate security so that a modem can originate a call using AT commands.

HEnable Originate Security

When using AT commands, the modem will only place a call if a valid password is entered along with an AT dial command. If the password is not entered, then ERROR is returned to the DTE, and the dial command is canceled.

NOTE: This configuration option enables or disables security protection used for outbound calls when using the AT command autodialer function.

3910-A2-GN32-40 September 1998 12-15