Digicom 3911, 3910 operation manual Online14.4 Control ExitRem

COMSPHERE 3900 Series Modems

If operation over the secondary channel is desired, press any function key to select the secondary channel. Secondary channel only appears if using V.32terbo, V.32bis, V.32 or TMp

modulation. If operation over the primary channel is desired, press the key until primary displays and press any function key. Primary channel operation is not available when initiating a Remote function from a TMp tributary modem.

Online:14.4

Control ExitRem

F1 F2 F3

If the remote modem accepts the password and the entry is successful, the Top-Level menu of

the remote modem appears on the local modem’s LCD. An appears in the upper right-hand corner indicating that what is displayed on your LCD is actually the Top-Level menu of the remote 391x Series modem. If the message Remote FP Busy appears, the remote modem’s front panel is already in Remote mode.

“Status”

Status

Configure

PList

Control

Test

SubHS

Call_Setup

ExitRe

m

The Top-Level menu of the remote 391x Series modem is similar to the local 391x Series modem with the following exceptions:

•The Talk/Data and Security branches do not appear.

•Change Directory is the only function available under the Call Setup branch.

•Local Analog Loop and Remote Digital Loop do not appear under the Test branch when using the secondary channel. When using the primary channel, the Test branch does not appear.

•Poll List Display is the only function available under the PList branch.

•Exit Remote replaces Remote on the local modem’s LCD.

To return to local modem operation, select ExitRem. Any changes made to configuration options in the remote modem are saved.

The following conditions can cause Remote branch access to fail:

•The local modem is not able to communicate with the remote modem because of a poor dial network or leased-line connection, or the remote modem is not a 3900 Series modem. If this is the case, the status message No Response appears on the LCD.

•If a connection is established but the remote modem’s Access from Remote configuration option is disabled, then the status message Access Disabled appears on the LCD.

13-4 September 1998 3910-A2-GN32-40