Digicom 3910, 3911 operation manual Configuration Tables, DTE Interface

DCP Configuration

Configuration Tables

The modem’s configuration options are arranged into nine groups based on functionality: DTE Interface (Table 5-1), DTE Dialer (Table 5-2), Line Dialer (Table 5-3), Dial Line (Table 5-4), Leased Line (Table 5-5), V.42/MNP/Buffer (Table 5-6), Test (Table 5-7), Misc (Table 5-8), and Security (Chapter 12).

Throughout these tables, two selections frequently appear on the LCD: Enable and Disable. Unless otherwise stated, Enable selects a configuration option and makes it available for use; Disable makes a configuration option unavailable for use.

NOTE

In some countries, the range of allowable values of some configuration options is restricted. The modem will accept any selection, but it will set the configuration option to the closest legal value. The actual value that is accepted by the modem is displayed when the F2 key is pressed to enter a selection.

DTE Interface

The DTE Interface configuration options contain EIA-232-D (ITU-T V.24) and asynchronous character format information essential for maintaining a connection and for transmitting data between the DTE and the modem.

Table 5-1 shows each DTE Interface configuration option as it appears on the LCD, with the Sync Leased factory default setting (the default value if the modem is just being installed) shown following the colon ( : ) on the first line and with all available selections listed on the second line. Following this is a description of the configuration option. Factory default settings are listed in Appendix F.

3910-A2-GN32-40 September 1998 5-9