Digicom 3911, 3910 operation manual 14-20

COMSPHERE 3900 Series Modems

Table 14-3

(6 of 13)

391x Series S-Registers

S-Register	Description	DCP LCD
		Command
		Sequence
S53	V.54 Address. Identifies the address of the modem to be placed in a	Configure\Edit\
	loopback test.	Tests
	Register has the following values:
	0 = Disable
	1–34 = Modem address
	The factory setting is Disable.
S54	V.54 Device Type. Identifies where the modem is physically located in	Configure\Edit\
	the network.	Tests
	Register has the following values:
	0 = Peripheral
	1 = Intermediate
	The factory setting is Peripheral.
S55	Access From Remote. Register determines if a modem’s DCP can be	Configure\Edit\
	accessed by a remote modem.	Misc
	Register has the following values:
	0 = Enable
	1 = Disable
	The factory setting is Enable.
S56	Remote Access Password. Register allows entry of the first pair	Configure\Edit\
	(leftmost) of digits of a remote access password. Any value from 00 to	Misc
	99 is valid. For example, if the remote access password is 12345678,
	then S56 = 1 and 2.
S57	Remote Access Password. Register allows entry of the second pair of	Configure\Edit\
	digits of a remote access password. Any value from 00 to 99 is valid.	Misc
S58	Remote Access Password. Register allows entry of the third pair of	Configure\Edit\
	digits of a remote access password. Any value from 00 to 99 is valid.	Misc
S59	Remote Access Password. Register allows entry of the fourth pair	Configure\Edit\
	(rightmost) of digits of a remote access password. Any value from 00	Misc
	to 99 is valid.

14-20 September 1998 3910-A2-GN32-40