Digicom 3911, 3910 operation manual Type Message Indicates Dial, Thresh, Security, Port

COMSPHERE 3900 Series Modems

		Table 4-1
		(2 of 2)
		Health and Status Messages
Type	Message	Indicates
Dial	Make Busy Mode	The modem is in a Make Busy condition.
	Service Line	(Model 3911 only) The modem installed in a COMSPHERE 3000
		Series Carrier has been switched to a service line.
	Short Hold Time	The modem’s dial hold time has been shortened.
	Non-Answering	The modem is in a non-answering mode.
Thresh*	RSL High	The received signal level (RSL) has exceeded the upper threshold.
	Threshd
	RSL Low	The RSL is less than the lower threshold.
	Threshld
	SNR Threshold	The signal-to-noise ratio has exceeded the threshold.
	Non-linear Dist	The non-linear distortion has exceeded the threshold.
	Retrains	The number of retrains has exceeded the threshold.
	Signal Quality	The signal quality is less than the threshold.
	Far Echo Threshd	The far end echo level has exceeded the threshold.
	Near Echo Thresh	The near end echo level has exceeded the threshold.
Security	Database Reset	The security database has been reset (passwords erased).
	Password Protect	Security password protection has been enabled.
	Mode Change	There has been a change in security mode. (Refer to Chapter 12, Dial
		Access Security.)
	Password	A security password has been changed.
	Change
	Database Change	The security database containing passwords has been changed.
Port 1	Rx Data Alarm	The DTE port’s RXD signal is in an alarm condition.
	Tx Data Alarm	The DTE port’s TXD signal is in an alarm condition.
	DTR Alarm	The DTE port’s DTR signal is in an alarm condition.
	CTS Alarm	The DTE port’s CTS signal is in an alarm condition.
	RTS Alarm	The DTE port’s RTS signal is in an alarm condition.
	DSR Alarm	The DTE port’s DSR signal is in an alarm condition.
	LSD Alarm	The DTE port’s LSD signal is in an alarm condition.
	Auto Stream Dis	The modem is in an Antistreaming condition. (Refer to the Streaming
		DTE message in the Major Alarm section of this table.)
	Disabled	The modem’s DTE port has been disabled.

*Not supported in every modulation.

To exit DeviceHS and remain in the Status Branch, press the key. To exit and return to the

Top-Level menu, press the key.

4-4 September 1998 3910-A2-GN32-40