Digicom 3910, 3911 Top-Level Menu Status, Status Message Indicates Normal, Operation, Call Setup

DCP Operation

		Table 3-3
		(1 of 3)
		Top-Level Menu Status
Status	Message	Indicates
Normal	Leased:MR*	The modem is operating on leased lines and transmitting at the
Operation		displayed data rate.
	Idle:MR*	The modem is configured for dial network operation and is on-hook.
	OnLine:MR*	The modem is online, in Data mode, and operating at the displayed
	EC**	data rate. EC (error control) appears if error control is operational.
	Ring Indicate	The local modem is receiving an incoming ring.
	Test:MR*	The modem is in test mode operating at the displayed data rate.
Alarm***	Make Busy	The modem is in a Make Busy condition.
	Power On Fail	The modem has failed its Power-On Self-test.
	SelfHealth Fail	A failure has occurred in the modem’s hardware components.
Call Setup	Off Hook	The modem is off-hook and waiting to dial a telephone number.
	Dialing	The originating modem is dialing a telephone number.
	Remote Ring	The remote modem is ringing.
	Training****	The modem is training or retraining.
	EC Negotiating	The local and remote modems are negotiating the highest possible
		level of error control compatible between both modems. Once a
		level is selected, this LCD message disappears.
Dial Backup or	Standby: MR*	The modem is operating in Dial Standby mode.
Leased Backup
	DialBckUp:MR*	The modem is operating in Dial Backup mode at the displayed data
		rate and is configured for Direct mode.
	Backup:MR*	The modem is operating in Dial Backup mode and is configured for
	EC**	error control and data compression on leased lines.
	Standby:MR*	The modem is operating in Dial Standby mode and is configured for
	EC**	error control and data compression on leased lines.

*MR. Modem Rate indicates the data rate the modem is using. One of the following values appears: 300, 1200, 2400, 4800, 7200, 9600, 12.0 (12,000), 14.4 (14,400), 16.8 (16,800), or 19.2 (19,200) bps.

**EC. Error Control indicates the modem is online and using V.42 or MNP error control. One of the following values appears after the modem rates listed above: MNP2, MNP3, MNP4, MNP5, V42, V42b, or NoEC. (NoEC indicates the modem is connected in Buffer mode rather than error control. If an EC value does not appear, then the modem is in Direct mode.)

***The Alarm Status Messages only appear when the Normal Operation Status Messages appear; the LCD alternates between the two message sets.

**** The Training message may also appear in normal Trellis Multipoint (TMp) operation.

3910-A2-GN32-40 September 1998 3-9