Emerson Process Management IM-106-340 Electrical Installation with Integral Electronics

Oxymitter 4000

Instruction Manual

IM-106-340, Rev. 4.0 May 2006

Figure 2-8. Installation with Drip Loop and Insulation Removal

Replace Insulation

after Installing

Oxymitter 4000

Insulation

Line	Logic I/O,
Voltage	4-20 mA Signal

				-	EVI	L	A
			E
			R
			E				T
	S	P	H				I
							U
M		-							I
T	G								R
									C
A	N
	I								N
	N
E R									E
V
SW									H
IA									W
O
	P								T
L-								H
	X						IG
			E
			N I		E		T
				-	KE	P

Drip

Loop

GAS

CAL.

Adapter Plate

Stack or Duct Metal Wall

29340005

ELECTRICAL INSTALLATION (WITH INTEGRAL ELECTRONICS)

For Oxymitter 4000 with Integral Electronics

All wiring must conform to local and national codes.

Disconnect and lock out power before connecting the power supply.

Install all protective covers and safety ground leads after installation. Failure to install covers and ground leads could result in serious injury or death.

To meet the Safety Requirements of IEC 1010 (EC requirement), and ensure safe operation of this equipment, connection to the main electrical power supply must be made through a circuit breaker (min 10 A) which will disconnect all current-carrying conductors during a fault situation. This circuit breaker should also include a mechanically operated isolating switch. If not, then another external means of disconnecting the supply from the equipment should be located close by. Circuit breakers or switches must comply with a recognized standard such as IEC 947.

2-10