Emerson Process Management IM-106-340 Oxymitter 4000 Setup AT the LOI, Do O2 Trim

Oxymitter 4000

Instruction Manual

IM-106-340, Rev. 4.0 May 2006

Figure 6-4. Menu Tree for Local Operator Interface (LOI) on the Oxymitter 4000 (Sheet 2 of 2)

(CONTINUED FROM

SHEET 1)

SYSTEM

Calib Setup

Input/Output

Parameters

Software

Status

Analog

Digital

O2 Gas 1	_____%
O2 Gas 2	_____%
O2-Reset Vals	Yes/No
O2 Out Tracks	Yes/No
O2 Cal Intervl	____H
O2-Next Cal	____H
Gas Time	___Sec.
Purge Time	___Sec.
Auto Calib?	Yes/No
O2 Type	_______
O2 Range	______%
O2 Alarm Level	_____mA
Do O2 Trim

Logic IO Mode See Table 4-1

Low O2 Alarm See “Abort

Calibration” in Section 9.

Input State

Force Output

O2 Slope	____ mV/D
O2 Constant	____ mV
O2 T90 Time	0:00
Auto Tune?	Yes/No
Lockout Time	0:00
Revert Time	0:00
Luminance	______
Version	xxx
Checksum	xxx
Build Number	xxx
Build Date	xxxxxx
Test Code	xx
SW Err File	xx
SW Err Line	xx
Alarms	__________
PID Parameters	115/220
Reset Device?	Yes/No

(Cal. required after reset)

NOTE

In column four of this menu, the selections in Italics are user configurable. Bold text selections are procedures; related instructions are displayed on the LOI. All other parameters are display only.

37260018

OXYMITTER 4000 SETUP AT THE LOI

In setting up the Oxymitter 4000 from the LOI, it is best to start at the SYSTEM/Calibration Setup menu, Figure 6-4.

SYSTEM/Calibration Setup

O2 Gas #1 - Enter the high or low cal gas value (the order is not important). O2 Gas #2 - Enter the second cal gas value.

NOTE

Refer to Section 9: Maintenance and Service, for calibration instructions.

6-6