Emerson Process Management IM-106-340 instruction manual Oxymitter Specifications

Oxymitter 4000

Instruction Manual

IM-106-340, Rev. 4.0 May 2006

SPECIFICATIONS

Oxymitter Specifications

O2 Range
Standard	0 to 10% O2, 0 to 25% O2, 0 to 40% O2 (via HART)
Accuracy	±0.75% of reading or 0.05% O2, whichever is greater
System Response to Calibration	Initial – less than 3 seconds, T90 – less than 8
Gas	seconds
Temperature Limits
Process	32° to 1300°F (0° to 704°C) up to 2400°F (1300°C)
	with optional accessories
Electronics Housing	-40° to 158°F (-40° to 70°C) ambient
Electronics Package	-40° to 185°F (-40° to 85°C) [Operating temperature
	of electronics inside of instrument housing, as
	measured by a HART communicator, Rosemount
	Analytical Asset Management Solutions software.]
Local Operator Interface	-40° to 158°F (-40° to 70°C), [above 158°F (70°C) the
	infrared keypad will cease to function, but the
	Oxymitter 4000 will continue to operate properly.]
Probe Lengths	18 in. (457 mm)		12 ft (3,66 m)
	3 ft (0,91 m)		15 ft (4,57 m)
	6 ft (1,83 m)		18 ft (5,49 m)
	9 ft (2,74 m)
Mounting and Mounting Position	Vertical or horizontal;
	a spool piece, (P/N 3D39761G02), is available to
	offset transmitter housing from hot ductwork.
Materials
Probe	Wetted or welded parts - 316L stainless steel (SS)
	Non-wetted parts - 304 SS, low-copper aluminum
Electronics Enclosure	Low-copper aluminum
Calibration	Manual, semi-automatic, or automatic
Calibration Gas Mixtures	0.4% O2, Balance N2
Recommended	8% O2, Balance N2
Calibration Gas Flow	2.5 l/m (5 scfh)
Reference Air	2 scfh (1 l/m), clean, dry, instrument-quality air
	(20.95% O2), regulated to 34 kPa (5 psi)
Electronics	NEMA 4X, IP66 with fitting and pipe on reference
	exhaust port to clear dry atmosphere
Electric Noise	EN 61326-1, Class A
Certifications	General Purpose
	C	US	APPROVED
Line Voltage	90-250 VAC, 48/62 Hz. No configuration necessary.
	3/4 in. -14 NPT conduit port

Table continued on next page

1-16