Instruction Manual

IM-106-340, Rev. 4.0 May 2006

Oxymitter 4000

GENERAL PRECAUTIONS FOR HANDLING AND STORING HIGH PRESSURE GAS CYLINDERS

Edited from selected paragraphs of the Compressed Gas Association's "Handbook of Compressed Gases" published in 1981

Compressed Gas Association

1235 Jefferson Davis Highway Arlington, Virginia 22202 Used by Permission

1.Never drop cylinders or permit them to strike each other violently.

2.Cylinders may be stored in the open, but in such cases, should be protected against extremes of weather and, to prevent rusting, from the dampness of the ground. Cylinders should be stored in the shade when located in areas where extreme temperatures are prevalent.

3.The valve protection cap should be left on each cylinder until it has been secured against a wall or bench, or placed in a cylinder stand, and is ready to be used.

4.Avoid dragging, rolling, or sliding cylinders, even for short distance; they should be moved by using a suitable handtruck.

5.Never tamper with safety devices in valves or cylinders.

6.Do not store full and empty cylinders together. Serious suckback can occur when an empty cylinder is attached to a pressurized system.

7.No part of cylinder should be subjected to a temperature higher than 52°C (125°F). A flame should never be permitted to come in contact with any part of a compressed gas cylinder.

8.Do not place cylinders where they may become part of an electric circuit. When electric arc welding, precautions must be taken to prevent striking an arc against the cylinder.

A-21

Page 169
Image 169
Emerson Process Management IM-106-340 instruction manual Oxymitter