Euphonix 5B Monitor Patching, Solo Bus and Utility Patching, Talkback Signal Patching

System 5-B Digital Audio Mixing System Operation Manual eMix Application

4.2.6Monitor Patching

The monitor outputs are automatically routed to the MC524 Monitor Controller sup- plied with System 5-B and are ready to be normalled to the speaker inputs. The monitor feeds are also available within PatchNet for routing to other destinations, if necessary.

Click on the Console I/O category and the Monitor Busses sub-category. This window shows all 22 monitor feeds:

Monitor	Busses	Format
1–8	Control Room	L, C, R, Sl, Sr, Bm, X, Y
9–16	Mon A	L, C, R, Sl, Sr, Bm, X, Y
17–18	Mon B	L, R
19–20	Mon C	L, R
21–22	Mon D	L, R

Table 4-1Monitor Bussses

The Cascade inputs allow for direct bus injection prior to the insert point into all mon- itor signal paths.

4.2.7Solo Bus and Utility Patching

The Solo Busses sub-category in Console I/O allows custom patching into the stereo Solo Bus.

The Utility Sources sub-category includes the Oscillator output. The Utility Destina- tions sub-category includes the Slate In which must be patched to the Talkback mic feed from the Monitor Interface.

4.2.8Talkback Signal Patching

The two talkback mics are wired to the MC524 Monitor Controller. They are summed and amplified to produce a single talkback signal. This analog signal must be fed into the system through an AM713 Analog to MADI converter.

To send talkback to the busses, this signal must be patched to the Slate Input (in the Utility Destinations subcategory of the Console I/O category). Note which AM713 analog-to-MADI converter input the talkback signal has been hardwired to and patch that channel to the Slate Input.

47