Extron electronic DXP DVI PRO manual Replacing Button Labels, Replacing a Button Label

5.After creating the labels, print them by selecting Print from the File pull-down menu in the upper-left corner of the Button Label Generator window. To save the button label set as an .xml file on your computer, select Save As from the File menu and enter a name for the label file.

Replacing Button Labels

The button assembly consists of a clear lens cap, the button label, and a white diffuser. Remove the button assembly from the DXP as follows:

1.Remove the button assembly by inserting a small, flat-bladed screwdriver, such as an Extron Tweeker, between the button base and the diffuser to gently pry the button assembly off the button plunger, as shown in figure 103.

2.Locate the small corner notch on the clear lens cap, and slide the screwdriver between the lens cap and the diffuser (see B in figure 103).

3.Using a rotating motion of the screwdriver, carefully pry the two pieces apart (see C in figure 103).

4.Lift out the transparent square label that you want to replace, being careful not to damage the circuits beneath it. You may need to use the small screwdriver to gently pry the label out.

5.Insert one of the new labels you created in before starting into the clear button cap, align the white backing plate with the cap, and firmly snap it into place.

6.Gently, but firmly, press the reassembled button into place on the DXP front panel.

7.Repeat steps 1 through 6 as needed to relabel other buttons.

Plunger

Base

Clear Lens	3	Diffuser
		Button Label
2	Pry the two
	pieces apart.
	Notch

Separating the two- piece button here at the corner.

Figure 103. Replacing a Button Label

DXP DVI, DXP DVI Pro, and DXP HDMI Series • Matrix Software 103